SSS/SSL Fuel & Water Tank Sensors (4 - 60 in.)

Length Measurement: Sending Unit length should be a minimum of one (1) inch less than the plastic tank depth, and three quarters (0.75) of an inch less than the metal tank depth. Note: If metal tank surface flexes, deduct one (1) inch from the depth. (like plastic tank)

Lengths Available: Four (4") through Ten (60") inches, with one half (0.5”) inch increments through 18.5”, and one (1) inch increments thereafter.. If you don't see your required size, click on the down arrow next to the closest size to your requirement.

Material: - 316 Type Stainless Steel and operate on a vertical plane (no float arm).

Mounting Method: SSS & SSL: - Standard SAE 5 hole patterns, 2.125” bolt circle, 240 – 30 ohm operation. Note: Units are supplied with a gasket, but without mounting screws.

Adapters:
FLSU: P/N 163303 @ $6.00 each. Under-ring for the SSS & SSL sender,  “C” shaped, 316 type ST/Steel adapter, threaded to the SAE 5 hole pattern, furnished with mounting screws. Can also be used for the SAE 5 hole pattern bolt circle (Inner bolt circle) on the FL2-WE.

Special Application Senders:
For Dual Station, Special ohms ranges (other than 240-30 ohms), Calibrated, Custom, Adjusted, or Special application units, contact us at info@wemausa.com or call us at 954-463-1075 or Fax: 954-463-1270.